CALL US

+86 17838360708

concrete mixer uniformity test

concrete mixer uniformity test

CRD-C55-92 Test Method for Within-Batch Uniformity of ...

2017-3-24  3.1 This test method is used primarily to provide a basis for establishing the minimum time of mixing re-quired to produce a batch of concrete from given mate-rials and proportions in a given concrete mixer with adequate uniformity of distribution of constituents in the batch. The performance of a given concrete mixer

get price

106.3.2.82 TM-82, Concrete Uniformity -

2016-6-8  106.3.2.82 TM-82, Concrete Uniformity This test method tests the uniformity of concrete. This is done by comparing the qualities of concrete at the beginning and end of a batch.

get price

Avoiding uniformity problems in truck-mixed concrete

Testing for mixing uniformity Standard Specification for Ready Mixed Concrete, ASTM C 94, con-tains uniformity testing procedures and requirements. Samples are tak-en from two parts of the batch and tested for slump, air content, strength, coarse-aggregate content, and air-free unit weight of concrete and of mortar. Usually, changes in

get price

Experimental Study on Gap-Graded Concrete Mixing

Abstract. Combining with the concrete mixing process of twin-shaft mixer, this paper studied the gap-graded concrete mixing uniformity variation under different time. The study found that: under ...

get price

Experimental Study on Gap-Graded Concrete Mixing

Experimental Study on Gap-Graded Concrete Mixing Uniformity p.42 Effect of Mineral Additives on Internal Relative Humidity and Dry Shrinkage of Light Weight Aggregate Concrete

get price

Ready mixed concrete: variability analysis of the ...

The NBR 12655 [13] recommends doing a uniformity test of mix-tures in concrete mixers, when show up signs of heterogeneity of compositional or consistency during discharge, but does not pro-vide more detailed information. Already ABECE [14] makes a rec-ommendation a little more complete, indicating regular quality con-

get price

State of Illinois

2021-7-30  FIELD TEST PROCEDURES FOR MIXER PERFORMANCE AND CONCRETE UNIFORMITY TESTS These methods describe the procedures for obtaining and testing representative samples of fresh concrete in the field to determine the consistency and mixer efficiency of stationary mixers at different mixing time periods.

get price

IS 4634 (1991): Methods for testing performance of

2018-11-14  Any test for the performance of concrete mixers has, therefore, to be based on the determination of the uniformity of the concrete, particularly as regards the even distribution of the constituents throughout the batch mixed by the mixer.

get price

Roller-Compacted Concrete Quality Control Manual

2018-10-11  Table 4.3 Uniformity Test Parameters Table 4.4 Tolerances for RCC Constituents Table 4.5 English Metric Conversion Factors FIGURES Figure 4.1 Vebe Consistency Test Figure 4.2 Preparation of RCC Cylinders with a Vibrating Hammer Figure 4.3 Preparation of RCC Cylinders with a Pneumatic Tamper Figure 4.4 Batch Type Concrete Plant Producing RCC

get price

Ready mixed concrete: variability analysis of the ...

2020-1-16  the mixer and the importance of quality control testing of concrete to certify the safety of structures, this study aims to analyze the uniformity of concrete mixtures in concrete mixer truck, during un-loading the material, to determine if there is significant variation in IBRACON Structures and Materials Journal • 2013 • vol. 6 • nº 1 195

get price

Experimental Study on Gap-Graded Concrete Mixing

Abstract. Combining with the concrete mixing process of twin-shaft mixer, this paper studied the gap-graded concrete mixing uniformity variation under different time. The study found that: under ...

get price

DETERMINATION OF THE UNIFORMITY OF MIXING OF

OSTI.GOV Technical Report: DETERMINATION OF THE UNIFORMITY OF MIXING OF PORTLAND CEMENT CONCRETE AND BITUMINOUS CONCRETE FOR VARIOUS MIXING TIMES BY THE USE OF RADIOISOTOPES. Quarterly Technical Status Report

get price

State of Illinois

2021-7-30  SUBJECT: FIELD TEST PROCEDURES FOR MIXER PERFORMANCE AND CONCRETE . UNIFORMITY TESTS . I. SCOPE. These methods describe the procedures for obtaining and testing representative samples of fresh concrete in the field to determine the consistency and mixer efficiency of stationary mixers at different mixing time periods.

get price

Use of a Moisture Sensor for Monitoring the Effect of ...

test methods can neither describe mixing efficiency nor monitor concrete uniformity. The present research is to explore a new approach to monitoring concrete mixture uniformity during mixing using an inserted moisture sensor. A great deal of work has been done using sensor technique to study properties of cement-based materials.

get price

CONCRETE MATERIALS AND TESTING - MnDOT

2008-5-5  CONCRETE MATERIALS AND TESTING 5-694.100 ... mixer. September 1, 2003 CONCRETE MANUAL 5-694.112 ... Therefore, to ensure uniformity of concrete color, where it is considered important, take special care to assure all conditions, as

get price

(PDF) CONCRETE MIX, SLUMP AND CONCRETE

The slump test is used to ensure uniformity for different loads of concrete under field conditions. The slump test is perhaps the most widely used because of the simplicity of the apparatus required and the test procedure. The slump test indicates the behavior of a compacted concrete cone under the action of gravitational forces.

get price

Effects of mixing procedure upon uniformity of fibre ...

2020-10-13  Test results show that the tensile strength of coJ1crete is increased appreciably by the inclusion of steel wire ... of mixing the reinforced concrete. Previous investigators have used several methods of introducing the wire fibres ... Effects of mixing procedure upon uniformity of fibre reinforced concrete ...

get price

Mixing efficiency of a concrete ribbon mixer and DEM ...

The ribbon concrete mixer with double barrels is commonly used to improve the uniformity of the fresh concrete in construction industry. In order to investigate the mixing efficiency of this kind ...

get price

Concrelab Material Testing Laboratories Construcción ...

2020-10-22  Fresh Concrete Test • Compressive Strength (ASTM C31) • Slump (ASTM C143) • Temperature (ASTM C1064) • Unit weight (ASTM C138) • Yield (yds3) (ASTM C138) • Air Content (ASTM C231, ASTM C173) • Mixing Uniformity (ASTM C94) Hardened Concrete Tests • Windsor Probe (ASTM C803) Non-Destructive Testing

get price

State of Illinois

2021-7-30  SUBJECT: FIELD TEST PROCEDURES FOR MIXER PERFORMANCE AND CONCRETE . UNIFORMITY TESTS . I. SCOPE. These methods describe the procedures for obtaining and testing representative samples of fresh concrete in the field to determine the consistency and mixer efficiency of stationary mixers at different mixing time periods.

get price

DETERMINATION OF THE UNIFORMITY OF MIXING OF

OSTI.GOV Technical Report: DETERMINATION OF THE UNIFORMITY OF MIXING OF PORTLAND CEMENT CONCRETE AND BITUMINOUS CONCRETE FOR VARIOUS MIXING TIMES BY THE USE OF RADIOISOTOPES. Quarterly Technical Status Report

get price

CONCRETE MATERIALS AND TESTING - MnDOT

2008-5-5  CONCRETE MATERIALS AND TESTING 5-694.100 ... mixer. September 1, 2003 CONCRETE MANUAL 5-694.112 ... Therefore, to ensure uniformity of concrete color, where it is considered important, take special care to assure all conditions, as

get price

Effects of mixing procedure upon uniformity of fibre ...

2020-10-13  Test results show that the tensile strength of coJ1crete is increased appreciably by the inclusion of steel wire ... of mixing the reinforced concrete. Previous investigators have used several methods of introducing the wire fibres ... Effects of mixing procedure upon uniformity of fibre reinforced concrete ...

get price

Concrelab Material Testing Laboratories Construcción ...

2020-10-22  Fresh Concrete Test • Compressive Strength (ASTM C31) • Slump (ASTM C143) • Temperature (ASTM C1064) • Unit weight (ASTM C138) • Yield (yds3) (ASTM C138) • Air Content (ASTM C231, ASTM C173) • Mixing Uniformity (ASTM C94) Hardened Concrete Tests • Windsor Probe (ASTM C803) Non-Destructive Testing

get price

REVISION OF CONCRETE PRODUCTION STANDARD NZS

2018-11-5  or more test samples with less within test controls. The criteria for assessing uniformity will remain the same and is shown in Table 1. Table 1: Performance test requirements for uniformity of concrete (NZS 3104 Table 2.7) Test method property Maximum permissible difference Plastic density of concrete 30 kg/m3 Slump 30 mm Air content 1.0%

get price

Truck Mixers Undergo Performance Tests Concrete ...

2021-7-29  Conducted by the Plainfield Division of Worthington Corporation, the major objective of the test was to provided more reliable data on truck mixer performance on the low slump harsh batches required for concrete used in paving work. The investigators hoped to

get price

Standard Practice for Determining Variability of Concrete ...

C109/C109M Test Method for Compressive Strength of Hydraulic Cement Mortars (Using 2-in. or [50-mm] Cube Specimens) C125 Terminology Relating to Concrete and Concrete Aggregates. C219 Terminology Relating to Hydraulic Cement. C494/C494M Specification for Chemical Admixtures for Concrete. D75/D75M Practice for Sampling Aggregates

get price

2004 CONCRETE MIX DESIGN GUIDANCE DOCUMENT-2

2006-4-7  2004 CONCRETE MIX DESIGN GUIDANCE DOCUMENT Prepared by the Construction Division of the Texas Department of Transportation for use in conjunction with the 2004 ...

get price

User's Guide to ASTM Specification C94 for Ready-Mixed ...

2020-10-15  continuous mixer, and delivered in a freshly mixed condition. Historically, the method of batching and mixing takes place in a truck-mounted unit specifically designed for this purpose. The C09.40 subcommittee is only one of many subcommittees which function as a part of the Committee C09 on Concrete and Concrete Aggregates.

get price